Designing single-stage power factor correctors and LC passive filters to comply with the new version of the IEC 1000-3-2 regulations
Autor
Villarejo Mañas, José Antonio; Lin, W.M.; Sebastián Zúñiga, Francisco Javier; Fernández Sarasola, Armando; Hernando Álvarez, Marta MaríaGrupo de investigación
División de Sistemas e Ingeniería Electrónica (DSIE)Área de conocimiento
Tecnología ElectrónicaFecha de publicación
2002-06Editorial
Institute Electrical and Electronics Engineers. (IEEE)Cita bibliográfica
VILLAREJO MAÑAS, José Antonio et al. Designing single-stage power factor correctors and LC passive filters to comply with the new version of the IEC 1000-3-2 regulations. Annual Power Electronics Specialists Conference (33º: 2002: Cairns, North Queensland, Australia ) 33th IEEE Power Electronics Specialists Conference, PESC'2002, Cairns, Queensland, Australia, June 23-27, 2002. Cairns, Queensland, Australia: IEEE. Vol 4, 2002. Pp. 2044-2049. DOI 10.1109/PSEC.2002.1023115Palabras clave
Norma IEC 1000-3-2Fuentes de alimentación
Niveles de potencia
Resumen
The design of low-cost power supplies is influenced by the regulations on the low-frequency harmonic content in the line. As IEC 1000-3-2 regulations have just been modified, the design procedure of low-cost power supplies should also be modified. According to the new version of the above-mentioned regulations, many power supplies classified as Class D in the past are classified as Class A now. This fact allows a remarkable saving in the sue of the reactive elements used to reduce the line harmonics if they have been properly designed. The minimum values of the magnetic elements used in two well-known PFC solutions (one is an S2PFC and the other is a passive fdter) have been obtained in this paper for equipment classified in both the new Class A and the new Class D and for any power level between 75W and 600W.
Colecciones
El ítem tiene asociados los siguientes ficheros de licencia:
Redes sociales